Structural Waterproofing
- United States
Fillets, Reinforcements, Terminations & Details
Bituthene® Edgeguard® Tape
A specially formulated tape designed for applications where resistance to hydrocarbon contaminated soil is required. It is made of a 0.05 mm (0.002 in.) polyester film with a pressure-sensitive solvent resistant acrylic adhesive. It is recommended for use over the membrane edges to protect the adhesive from prolonged exposure to hydrocarbon contaminated soil.
|
DATA SHEET
|
Bituthene® Liquid Membrane
A two component, elastomeric, cold-applied, trowel grade material designed for a variety of uses with the Perm-A-Barrier air barrier systems and Bituthene Waterproofing System. Ideally suited for use as a fillet material at inside corners; reinforcement at inside corners, flashing material around drains, protrusions, curbs and parapets; sealing material at terminations; repair material for defects on concrete surfaces; and as a flashing material at corners.
|
DATA SHEET
|
Bituthene® Mastic
A rubberized asphalt-based mastic. It has excellent adhesion to structural concrete, masonry, glass-mat faced gypsum sheathing and wood and is designed to seal terminations, edges of patches, and overlaps in detail areas. It is an integral part of the Bituthene Waterproofing System, though it should not be used as a primary waterproofing material. It is compatible with all Perm-A-Barrier self-adhered air barrier and flashing membranes.
|
DATA SHEET
|
Hydroduct® Tape
A specially formulated, two-sided highly aggressive adhesive tape recommended for adhering Hydroduct drainage composites, expanded polystyrene protection board or insulation, or extruded polystyrene protection board or insulation to Bituthene® membranes. May also be used for additional protection when forming end laps with Preprufe membranes.
|
DATA SHEET
|
Preprufe® Tape
A specially formulated two sided, reinforced pressure-sensitive tape. The bottom side has a highly aggressive, pressure-sensitive adhesive designed to adhere to penetrations, protrusions and Bituthene membranes. The topside has another layer of adhesive and a coating that protects the tape from the weather and UV light for up to 30 days following application. Used in detail areas including end laps, penetrations and various tie-ins.
|
DATA SHEET
|
|
